Winco 2-Wire Conversion Instructions ULPSS12H2W/E User Manual download pdf

INSTALLATION INSTRUCTIONS FOR 2-WIRE

AUTO START CONTROL CONVERSION

The following instructions are provided to convert the ULPSS12H4W/E

from a special 4-wire start system to a standard 2-wire Auto Start Sytem.

Items required:

WINCO Conversion Kit # 16448-006 Auto Start (for ULPSS12H2W/E)

T25 Torx Screwdriver

7/16” End Wrench or Socket & Driver

PROCEDURE

1. Move the left hand toggle switch “A”

to the “STOP” position.

2. Remove the battery negative (-)

cable if the battery is installed.

3. Unplug the wiring harness “D”.

4. Remove the two bolts “B” and remove

the circuit breaker cover panel “E”.

5. Remove the 4 torx screws “G” from the

tower assembly.

6. Remove the 4-wire controller “C” by

pulling it forward.

7. Install 2-wire controller “F” by pushing

the controller back into position.

8. Re-install the 4 torx screws “G”.

9. Re-connect the wiring harness “D”.

1 2 3

AUTO START CONTROL CONVERSION 1

Summary of Contents

Page 1 - AUTO START CONTROL CONVERSION

INSTALLATION INSTRUCTIONS FOR 2-WIREAUTO START CONTROL CONVERSIONThe following instructions are provided to convert the ULPSS12H4W/E from a special 4-

Page 2

10. Locate the 2-wire white connector, hanging loose on the right hand side of the control tower. Attach it to the matching connector “H” on the bott

Page 3

WINCO INC.225 S. CORDOVA AVE.LECENTER, MN 56057507-357-6821SERVICE DEPT.507-357-683

Comments to this Manuals

No comments

Winco 2-Wire Conversion Instructions ULPSS12H2W/E User Manual

Browse online or download User Manual for Equipment Winco 2-Wire Conversion Instructions ULPSS12H2W/E. Winco 2-Wire Conversion Instructions ULPSS12H2W/E User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Winco 2-Wire Conversion Instructions ULPSS12H2W/E