Winco GM100 User Manual

Operator Manual Auto Start Generator Controller Mechanical Diesel or Gaseous Engines Part Number: GM100 14 (102-2003) Version 1.0 _______

7. Auxiliary Input / Output Connections 7.1 Aux Inputs 7.1.1 Fuel Level - An analog fuel level sender input is located on the terminal strip insid

8. Engine Sender Types • Oil Pressure – Stewart Warner 240 – 33 ohm, 0-100 PSI (SD0006 Including with K part numbers) • Engine Temperature – Stewa

9. Generator Sensing • AC Voltage – Directly from generator output, Up to 600 VAC • AC Current – Current transformers, 5 Amp output (XXX: 5). Tw

10. Control AC / DC Adjustments AC Volts Adjust AC Amps Adjust 485 Port Battery Adjust AC Circuit Board CT Input AC VoltageInput 10.1 AC Voltage

13 11. Product Warranty CONTROLS, INC. is herein called “Seller”. The person, firm or corporation to whom or which the sale is made is herein cal

1Basic Controller Operation 1) Manual Start a. Place selector switch in the RUN position. b. Controller will begin start sequence. • Preheat (i

1. Introduction The GM100 is a microprocessor-based controller for industrial engines. It is based on the Controls, Inc. 1100-000 series controller

2. Interface • LCD Display – The backlit digital display is 1”H x 4”W with two rows of 16 characters. Character height is approximately ½”. • E

3. Enclosure • The product is housed in an 14”W x 10”H x 10”D metal enclosure and supplied with four vibration isolators to mount the unit to a hori

4. Engine Start & Stop 4.1 The controller is manual and auto start capable. 4.1.1 Manual Operation 4.1.1.1 Turn the panel selector switch t

5. Engine Speed (Frequency) Calibration 5.1 Panel must be calibrated to engine flywheel for proper frequency display. 5.2 Controller default is 1

6. Engine Pre Alarms & Alarms The controller monitors engine oil pressure, engine temperature and engine speed directly using sensors. If measu

6.2 Engine Faults 6.2.1 In the case of an engine alarm, the red LED will illuminate. 6.2.2 The controller will open the run circuit causing the